| Age | Commit message (Collapse) | Author |
|---|
|
reset_gpio is claimed in mdiobus_register_device(), but it is not
released in mdiobus_unregister_device(). It is instead only
released when the whole MDIO bus is unregistered.
When a device uses the reset_gpio property, it becomes impossible
to unregister it and register it again, because the GPIO remains
claimed.
This patch resolves that issue.
Fixes: bafbdd527d56 ("phylib: Add device reset GPIO support") # see notes
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Cc: Csókás Bence <csokas.bence@prolan.hu>
[ csokas.bence: Resolve rebase conflict and clarify msg ]
Signed-off-by: Buday Csaba <buday.csaba@prolan.hu>
Link: https://patch.msgid.link/20250807135449.254254-2-csokas.bence@prolan.hu
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
|
|
Make mdio_device_bus_match() the default match function for non-PHY
MDIO devices. Benefit is that we don't have to export this function
any longer. As long as mdiodev->modalias isn't set, there's no change
in behavior. mdiobus_create_device() is the only place where
mdiodev->modalias gets set, but this function sets
mdio_device_bus_match() as match function anyway.
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Link: https://patch.msgid.link/6c94e3d3-bfb0-4ddc-a518-6fddbc64e1d0@gmail.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
|
After 52358dd63e34 ("net: phy: remove function stubs") there's a
problem if CONFIG_MDIO_BUS is set, but CONFIG_PHYLIB is not.
mdiobus_scan() uses phylib functions like get_phy_device().
Bringing back the stub wouldn't make much sense, because it would
allow to compile mdiobus_scan(), but the function would be unusable.
The stub returned NULL, and we have the following in mdiobus_scan():
phydev = get_phy_device(bus, addr, c45);
if (IS_ERR(phydev))
return phydev;
So calling mdiobus_scan() w/o CONFIG_PHYLIB would cause a crash later in
mdiobus_scan(). In general the PHYLIB functionality isn't optional here.
Consequently, MDIO bus providers depend on PHYLIB.
Therefore factor it out and build it together with the libphy core
modules. In addition make all MDIO bus providers under /drivers/net/mdio
depend on PHYLIB. Same applies to enetc MDIO bus provider. Note that
PHYLIB selects MDIO_DEVRES, therefore we can omit this here.
Fixes: 52358dd63e34 ("net: phy: remove function stubs")
Reported-by: kernel test robot <lkp@intel.com>
Closes: https://lore.kernel.org/oe-kbuild-all/202504270639.mT0lh2o1-lkp@intel.com/
Reviewed-by: Jacob Keller <jacob.e.keller@intel.com>
Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
Link: https://patch.msgid.link/c74772a9-dab6-44bf-a657-389df89d85c2@gmail.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
|
