| Age | Commit message (Collapse) | Author |
|---|
|
The i2c adapter for ddc might not be available yet due to e.g. its
module not yet being loaded. To handle that defer probing rather then
returning a fatal error when probing.
Signed-off-by: Sjoerd Simons <sjoerd@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
|
Add support for the newer HDMI-TX (Encoder) v2 and DDC v2 IPs
found in MediaTek's MT8195, MT8188 SoC and their variants, and
including support for display modes up to 4k60 and for HDMI
Audio, as per the HDMI 2.0 spec.
HDCP and CEC functionalities are also supported by this hardware,
but are not included in this commit and that also poses a slight
difference between the V2 and V1 controllers in how they handle
Hotplug Detection (HPD).
While the v1 controller was using the CEC controller to check
HDMI cable connection and disconnection, in this driver the v2
one does not.
This is due to the fact that on parts with v2 designs, like the
MT8195 SoC, there is one CEC controller shared between the HDMI
Transmitter (HDMI-TX) and Receiver (HDMI-RX): before eventually
adding support to use the CEC HW to wake up the HDMI controllers
it is necessary to have support for one TX, one RX *and* for both
at the same time.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-9-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
ddc_v2
ddc_v2
|
|
Add an interlace_allowed bool member to struct mtk_hdmi_ver_conf
which will be used to signal whether interlaced modes are supported
by the bridge (in our case, the HDMI IP), and enable it for HDMIv2.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-8-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
|
In preparation for adding the HDMI TX v2 driver, and to allow
a future modernization of the HDMI v1 one, perform changes
that enable the usage of the HDMI Helpers provided by DRM.
Check if the HDMI driver provides the function pointers to
hdmi_{clear,write}_infoframe used by the HDMI Helper API and,
if present, add DRM_BRIDGE_OP_HDMI to the drm_bridge ops,
enabling the drm API to register the bridge as HDMI and to use
the HDMI Helper functions.
If the hdmi_{write,clear}_infoframe pointers are not assigned,
vendor and product strings and HDMI helpers will not be used,
hence this commit brings no functional changes to drivers that
have not been refactored to use the new helpers.
This also means that, in the current state, there is effectively
no functional change to mtk_hdmi and its other components.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-7-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
|
In preparation for adding the new HDMI TX v2 IP driver, assign the
pointer to the DDC adapter to struct drm_bridge during probe.
This commit brings no functional changes.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-6-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
|
In preparation for adding a new driver for HDMIv2, for which CEC
is not strictly required, change the of_get_compatible_child()
failure error to -EOPNOTSUPP to be able to differentiate between
error conditions in mtk_hdmi_dt_parse_pdata().
In that case, if -EOPNOTSUPP is returned, this driver will print
an informative message saying that CEC support is unavailable,
as the devicetree node for that was not found, but after that,
function mtk_hdmi_dt_parse_pdata() will not return error to
the caller.
This will not change functionality of the mtk_hdmi (v1) driver
as that is still checking whether CEC is present and, if not,
will fail probing with an error saying that CEC is required
by HDMIv1.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-5-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
|
In preparation for adding a new driver for the HDMI TX v2 IP,
split out the functions that will be common between the already
present mtk_hdmi (v1) driver and the new one.
Since the probe flow for both drivers is 90% similar, add a common
probe function that will be called from each driver's .probe()
callback, avoiding lots of code duplication.
Reviewed-by: CK Hu <ck.hu@mediatek.com>
Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Signed-off-by: Louis-Alexis Eyraud <louisalexis.eyraud@collabora.com>
Link: https://patchwork.kernel.org/project/linux-mediatek/patch/20251023-mediatek-drm-hdmi-v2-v11-4-7873ec4a1edf@collabora.com/
Signed-off-by: Chun-Kuang Hu <chunkuang.hu@kernel.org>
|
